• Contact Us
  • Select a Location
    Close Location Selection

    Current Location:

    Let us know the location you'd like to browse.

    Select a Location
    OR

Netgear CM700

Details

     

Modem Information

DOCSIS 3.0 Cable Modem

32x8 channel bonding

To achieve Gigabit speeds or higher, a DOCSIS 3.1 modem is required

Highest Service Level

Go Even Faster - 500 Mbps

   

Front View

Front View

Click to enlarge.

After the cable modem successfully registers on the network, the Power, Upstream, Downstream, and Internet indicators continuously indicate that the modem is online and fully operational. For more details, refer to the Modem Lights section.

     

Back View

Back View

Click to enlarge.

 

The modem includes the following connection ports:

  • Ethernet - Connects to the Gigabit Ethernet cable.
  • Reset - Use this button in the unlikely event that you want to restore the default factory settings. This button is recessed to prevent accidental resets of your modem.
  • Cable / Internet - Connect your coaxial cable line to this port.
  • Power - Connect the supplied power cord to this port.
  • On / Off - Turns modem on and off.
     

MAC Address

MAC Address of Netgear CM700

Click to enlarge.

 

The MAC Address and Serial Number information are at the modem's bottom.

Troubleshooting

The lights indicate the current status of your gateway. To troubleshoot any connection problems, use the table below.
 

Modem Light Status Problem
Power

power
Off No power
Green None
Red The cable modem is too warm and might overheat
Downstream

downstream
Blinking Green Scanning for downstream channel
Solid Amber None - connection established on one channel
Solid Green None - operating on more than one channel
Off Downstream channel inactive
Upstream

upstream
Off Upstream channel inactive
Blinking Green Scanning for upstream channel
Solid Amber None - connection established on one channel
Solid Green None - operating on more than one channel
Internet

internet
Off Modem offline
Blinking Green None - scanning for configuration parameters
Solid Green None - operational
Ethernet

ethernet
Off A device is not connected to the Ethernet port on the back.
Solid Green None - A device is connected to the Ethernet port.

Manufacturer Resources

For more detailed technical information, use the resources below.
 

Data Sheet (PDF)

Search for More Articles