Internet
The Internet should add convenience, not headaches. From step-by-step instructions to helpful tips, we'll help you install your equipment, troubleshoot problems, and get the most out of your online experience – minus the migraine.
Connect a Home Gateway With an Ethernet Connection
Last Updated: Wed, 26 Sep 2012 > Related Articles
Summary
This article provides information on how to connect the Cisco DPC3825 and Netgear CG3000D home gateways with an Ethernet connection.
Solution
Items needed for an Ethernet installation
- Operating System CD
- Gateway
- Ethernet Cable
- Coaxial Cable
Note: If you are using a hub to connect multiple wired computers, a crossover cable may be required.
Connect one end of the coaxial cable to the cable wall outlet and connect the other end of the coaxial cable to the gateway.
Plug the gateway power adapter into a wall outlet and the other end into the gateway.
Note: Most gateway are "on" all the time and do not have a switch. If the gateway has a power switch, turn on the gateway and wait for the gateway to synch with the cable network.
Connect one end of the Ethernet cable into the back of the gateway and the other end into the back of the computer.
Check the gateway lights for proper status. Refer to the following articles:
Most gateway lights operate similarly. Some blink at start-up, then become steady, except for the “activity” light, which may blink continuously. If the gateway lights do not come on, turn off the computer, unplug the gateway, wait 30 seconds, plug the gateway back in, then restart the computer.Need more help?
-
Technical SupportLive Chat
-
Send an Email toCox.com
-
Join the DiscussionSupport Forums
-
Find your nearestService Center
-
Give us a call24/7 Phone Support
-
Additional ContactsLocal Information