Learn how to protect, connect, and relax with support for your Home Security service. From arming and disarming your alarm, to managing your portal, Cox Home Security Support helps you with troubleshooting and step-by-step solutions.
Replacing the Guest Key Fob Battery for Cox Home Security
Last Updated: Mon, 31 Mar 2014 > Related Articles
Learn how to replace guest key fob batteries to ensure your devices are working to properly arm and disarm your Cox Home Security system.
To replace the batteries in your Cox Home Security guest key fob, you need a CR2032 3-volt lithium battery. A flathead screwdriver is the recommended tool to help replace the battery. Follow the steps below to properly replace your guest key fob battery.
Holding the key fob in one hand, carefully insert the tip of a flathead screwdriver into the casing seam.
Push lightly and twist the screwdriver handle.
Remove the circuit board and rubber button pad from the key fob casing.
Note: If present, remove using the clear plastic strip from under your battery.
Insert the new CR2032 3-volt lithium battery into the battery slot, with the positive side facing away from the circuit board.
Replace the circuit board in the key fob casing and the rubber button pad in the key fob casing.
Important: Ensure the buttons are replaced correctly with the red panic button on the bottom, near the key ring.